after three connection errors with the card, the driver tries to restore the connection every 30s (an attempt to re-establish the connection takes about a minute)
after a reset of the card's power supply or a transmission error, the driver tries to connect to the card every 30s
the connection status with the Dome and Shutter card is reported in the Sensors tab in the main program window
card status is read once per second, it should greatly improve the stability of the card
Observing Condition interface reports UnSafe status in case of connection problems with the Shutter card
5.5.23 (2021.08.24)
corrected bug in Arduino_Test_App password settings
added AAG Solo driver
5.5.22 (2021.06.16)
added Watchdog for Shutter Link lost - driver now can exequte special script in this situation
added ASCOM Observing Conditions interface
added ASCOM Safety Monitor interface
corrected bug in thermometers settings save
corrected bug in telescope Alt/Az to Ra/Dec calculation
5.5.20 (2021.04.10)
better support for number formats for different Windows language versions
corrected bug in Shutter Emergency Close on Low UPS Battery
corrected lot of small bugs
new card firmware ver. 5.7 release
driver save and restore graphs values
driver is ready for card LCD display
5.5.5.19 (2021-03-11)
better and much more help files
corrected bug in Thermostates for RollOff mode (there was wrong Histeresis parameter send to the card)
corrected bug in Shutter Emergency Close on Low Battery
better Heating system interface
new buttons commands for enable and disable all thermostats
new Tab in Cofig window for display, select and configure active thermometers/sensors
driver remember selected graph configuration
new short one line log for ScopeDome Cloud Sensor
5.5.5.18 (2020-10-21)
new firmware release ver. 5.4
added delay for Clamshell Shutter in firmware
better findeHome procedure
added CloudSensor statistic for clear sky
corrected Rain Sensor bug for Clamshell and RollOff Roof
added config parameters change log
added shutter link value to the log
small changes in interface design
added ASCOM telescope choser for better compatibility with ASCOM 6.5
5.5.5.16 (2020-09-08)
new firmware release ver. 5.3
added control for card PWM outputs
better logs on driver window
added scripts support (batch commands, vbs scripts and driver scripts)
lot of new commands for control telescope
5.5.5.15 (2020-03-20)
corrected bug in Shutter Emergency Close procedures (repeated close command when shutter was close)
add ASCOM POTH telescope type
add ASCOM HUB telescope type
5.5.5.14 (2020-03-10)
corrected Shutter Stop bug
new weather station (Weather Underground API, Boltwood Single Line log, Boltwood via date log)
